Here we go again. This time, it's a gadget that I spent an idle 10 minutes knocking up from a spare bit of ally sheet.
Archive for the 'Making stuff' Category
Making stuff
At last I got some time between DIY jobs to make a few of the things that I can't be arsed to buy, or which just can't be had at the shops.
First up - I made a footprint for the Vango Spectre tent. Same plan as usual - get a cheap green woven plastic tarp from the Pound Shop (cost 50p, no, I can't figure that either), cut to shape, fold over the cut edges and iron them down to make them stick. The addition of three plastic eyelets (10p each) is the only other cost. Making a few X-shaped cuts in the fabric (for drainage) finishes the job.
Next up - a reflector for the Nikon remote unit. The D50's IR sensor is on the front of the body, so it doesn't detect a signal from behind. There are a few proper gadgets available for dealing with this situation, all of them involve an unwieldy fixed-attitude plastic reflecting plate that's attached to the lens with a bit of bungee cord, like this:
I made a more compact hinged version by cutting down a redundant sd-card case and attaching a rubber band. Using this, the remote works a treat from behind and from the side, and the whole thing is a better fit into my camera case.
Finally - pull-loops for the latest batch of Alpkit Tikes. These pegs come with a length of heavy-duty red cord attached, it's fine for most applications but I find that a) the bulk takes up room in the pack which I could use for something else, and b) the red colour is difficult to see at night. Said cords have been replaced with off-cut lengths of fluoro-yellow dyneema which is much easier to see in the dark and which has very little bulk. You can just about see them in the following picture of the "big red slug":
